Restart of Submodel in Abaqus

Hi everyone,

Currently, i have a problem concerning Restart of submodel in the Abaqus software. I used the submodeling technique for my research. However its analysis is interrupted by a convergence problem. Therefore, i applied the restart technique in Abaqus for continuing this interrupted analysis. And another occurred problem in the submodel restart is that i could not apply exactly the boundary conditions of the driven nodes for the submodel in the interrupted time increment. This causes of the difference between analysis step time of submodel restart and the global analysis step time.For example: - Analysis step of global model: 20s (= step time of submodel)
- Interrupted time in submodeling analysis: 5s at increment 20

My restart file:

--------------------------------
*Heading
*Restart, read, step=1, inc=20, end step
....

*Step, name=Step-2, inc=5000
*Static
0.01, 15, 1e-6, 1.
*Boundary, submodel, step=1
DRIVEN-NODES, 1, 3
*Temperature, amplitude=TEMPERATURE
ALLNODES, 1.
*restart, write, frequency=1,overlay
...
*End Step
-------------------------------------

If i use this restart file, the boundary condition applied to submodel in restart analysis begins at t=0s of global analysis step time but not t=5s (interrupted moment of previous submodeling analysis)

I lost quite a lot of time to solve this problem but not possible. I hope you can give me a solution or suggestion to solve this problem?

Thank you in advance.

Best regards.