User login

Navigation

You are here

kdevarajanmts's blog

How to extract global and stiffness matrix for rotating beam from Ansys?

Hello Everyone,

 I am currently doing research on Modal analysis of rotating cantilever beam using finite element analysis. For my research i want to extract global stiffness and mass matrix for rotating beam. I am using ANSYS 14.5 for my analysis. Please anybody know this means please kindly reply .

 

Expecting a posiitve reply,

 

With Regards

Devarajan K

Assistant professor

 

Flow Induced Vibration in pipe flow

Hi all

 

I am doing flow induced vibration analysis in pipe using ansys workbench. First i created fluent model and this output(solution) is couple with tranient structural  setup. FInally the pipe gets displaced becuase of fluid pressure. After that i want to calculate the modes. So it is possible to couple transient structural solution to modal setup? I have tried but i didnt know how to couple modal analysis and transiest structural analysis. Please help me regarding in this.

 

Waiting for yours reply

 

Devarajan K

How to create a delamination in laminate composites using Abaqus

Dear all,

I am Devarajn K, working as a assistant professor at Amrita School of Engineering. Now i am doing project in composite plate with delaminations. I dont know how to create delamination in composite using abaqus. can anybody help me regarding in this

 

I am expecting a positive reply

 

Devarajan K

How to create a Duplicate nodes in abaqus

Dear sir,

 

Can anybody help me regarding how to create a duplicate nodes in abaqus. 

 

Thanks and regards

Deavarajan K

Adiabatic Boundary Conditions

Hello Sir's,

 

Journal search engine

Impact load on cantilever beam using

Hello Every one..

 

      I am Devarajan.K I am New to abaqus. i want to anaysis vibration on cantilever beam when impact load acting on the beam. i dont know how to give   impact load on the beam. only ramp input load is there in abaqus. please help in this regarding how to give impact load on beam. please let inform me as soon as possible. this is my project work.

 

Thanks nd Regards

 

Devarajan.K 

 

Mass scaling factor in abaqus

dear sir

 

i am rolling of thick plates analysis in abaqus.Completing one analysis it took 10-15 minutes. i want to do minimum 35 analysis by cahnging the rolling paramters. some one told me that if you are giving the mass sacling factor means CPU time will reduce, and process will complete as soon as possible. my stip lenthg is 100mm and thick ness is 6mm, and feed rate is 20m/s. please can tell me how to give mass sacling value for this problem.

 

Thank you very much

Devarjan,K

Optimisation of influence of rolling paramters in cold rolling process

Respected sir/Madam,

I am Devarajan.K Doing M.Tech Engineering design . I am currently doing projects in  Optimisation of influence of rolling paramters in cold rolling process . For this i choosed the following input parameters of rolling process

1. Roller Diameter

2.Roller Speed

3. Friction Coefficient

4.Inlet material thickness

5.% of reductions

Abaqus

 hello everyone.

 

iam devarajan.k currently pursuring M.Tech in Engineering Design in Amrita University and doing projects on hot rolling of thick plates.For FEm simulation iam using ABAQUS software. After material rolled, i want to quench that material into water or some other material. i dont know how to do this in abaqus. please guide me if any one know this. please

 

With Regards

Devarajan.K

Subscribe to RSS - kdevarajanmts's blog

Recent comments

More comments

Syndicate

Subscribe to Syndicate