You are here
Deformation Shape doesnt show up
Hi everyone,
well, im glad i found this forum dedicated to
abaqus users. i'm just a rookie, got in touch with abaqus in less than
a month for my thesis. hope you can help in my first big struggle.
im
modeling a nut and a bolt thread in 2d, they should move towards
eachother and upon contact they should crash past eachother. i went
through all the modules quite ok. i run the job, it is successful. in
the visualization window, when i try to see the deformation of the
threads the following message is displayed:
"Deformation and/or analytical surface extent is too large as compared with the model."
help...
Comments
You can reduce the
You can reduce the magnitudes of the loads, or velocity what ever you gave... Give minium and see the response. Also check the boundary conditions.
If this doesnt work, check the property of your material. See to it that you defined the properties correctly.
Hope this would work.
Thanks & Regards
Hardik Singh