You are here
Apply pressure load
Thu, 2009-12-10 05:29 - M Vettorato
How can you apply a pressure, not normal to a angled face in a 3D model in Abaqus? Is that possible? See sketch: P --> /
Regards
»
- M Vettorato's blog
- Log in or register to post comments
- 2417 reads
Comments
perhaps use normal and tangential components
It might be that you need to apply components of the pressure to get the desired result. In other words normal components and tangential components. The net result of these components should be selected to get the result that you seek.
regards,
Louie