how to mesh two sucessive volumes with different meshing
i've modeled a column as a volume
i need a closer or finer mesh near the junction of beam
anyone pls guide me on this issue???
You may consider the following two ways:
1. You can use different mshing in different parts, and then use multi-point constraint to constrain the displacement in the connecting region of different meshes.
2. You can use bias meshing in the connecting region.
Madam,Thank you very much, your reply.
How to apply the Reversal load steps using Ansys,
Mono tonic load application of the load steps not a problem & performance also I am getting as per the laboratory results crack patens
Thanks & regards
s.raja
Comments
MPC
You may consider the following two ways:
1. You can use different mshing in different parts, and then use multi-point constraint to constrain the displacement in the connecting region of different meshes.
2. You can use bias meshing in the connecting region.
Madam,Thank you very much,
Madam,Thank you very much, your reply.
How to apply the Reversal load steps using Ansys,
Mono tonic load application of the load steps not a problem & performance also I am getting as per the laboratory results crack patens
Thanks & regards
s.raja