Hello everybody,
I am trying to apply the tie constraint to two parts with different degree of mesh density. This works fine but when I apply the penalty contact method with friction between the modified parts and a third part, I obtain the following message;
Abaqus Error: The executable explicit_dp.exe
aborted with system error "Illegal memory reference" (signal 11).
Please check the .dat, .msg, and .sta files for error messages if the files
exist. If there are no error messages and you cannot resolve the problem,
please run the command "abaqus job=support information=support" to report and
save your system information. Use the same command to run Abaqus that you
used when the problem occurred. Please contact your local Abaqus support
office and send them the input file, the file support.log which you just
created, the executable name, and the error code.
Abaqus/Analysis exited with errors
and there are no errors reported in any of this files. Does anyone have any idea or experience with such a problem?
Regards,
Rex
Forums