Create part, 3D, solid, type revolution, continue and in the sketch pattern that appears, draw half of an ellipse on one side of the centerline (with a closed section), then press done and in the window that appears set the revolution angle equal to 360 degrees.
George Papazafeiropoulos
First Lieutenant, Infrastructure Engineer, Hellenic Air Force
Create ellipsoidal model in Abaqus/CAE
Create part, 3D, solid, type revolution, continue and in the sketch pattern that appears, draw half of an ellipse on one side of the centerline (with a closed section), then press done and in the window that appears set the revolution angle equal to 360 degrees.
George Papazafeiropoulos
First Lieutenant, Infrastructure Engineer, Hellenic Air Force
Civil Engineer, M.Sc., Ph.D. candidate, NTUA
Email: gpapazafeiropoulos [at] yahoo.gr (gpapazafeiropoulos[at]yahoo[dot]gr)
Website: http://users.ntua.gr/gpapazaf/
In reply to Create ellipsoidal model in Abaqus/CAE by George Papazaf…
create a half of an ellipse
Thanks!But how can i create a half of an ellipse on one side of the centerline? I can draw whole ellipse only.