You are here
modeling corroded pipe with Abaqus
Wed, 2009-02-25 13:52 - badr
Hello everyone,
I'm doing a 3D modelingcorroded pipe. The results is differant from the Analytical solution (modified N31G mathod). Abaqus results is actualy half of the analytical solution.
I need some help whith:
1- Half of the pipe was modeld so, how should i constrain the pipe? I constrained it as in the attached picture.
2- How can i know how much load was applyed?
3- how can i magnifiy teh displacment?
Thank you,
Badr
Forums:
Recent comments