You are here
Nice Imechanics
Mon, 2007-06-11 01:50 - Databa
Hi, I am a newcomer. This is a nice place. a lot of useful information.
»
- Databa's blog
- Log in or register to post comments
- 11648 reads
Comments
How to simulate simulate the drilling process with ANSYS
Hi we would like to know if anyone knows if it is possible to simulate drilling a hole in a metal sheet.We want to simulate in Ansys the stress relaxation after drilling a hole. Best regards,Bruno Serrano
problem when using chesive element, seeking help
Hi, I use the chesive element to simulate the debonding of particle in matrix.
I edit the mesh to make the thickness of chesive element to be zero. When I submit the job,
errors comes:
The geometry of 30 elements is too distorted. Check the nodal coordinates or node
numbering on elements identified in element set ErrElemDistorted.
If I don't make the thickness to be zero, it goes well with ABAQUS 6.10.
Can anyone help me?
About Cohesive Element
Hi,
Is the element is Cohesive Element or not. If it is Cohesive Element, I think you cannot set the thickness to zero. You can set to a very small value or set a defaut number (maybe 1) which idicate ignore the cohesive layer.