You are here
XFEM for rock in ABAQUS
Hi
I tried to simulating crack propagation with XFEM method in porous media (rock), but got error code 144 (like this error" the executable C:\SIMULIA\Abaqus\6.9-1\exec\standard.exe aborted with system error code 144. Please check the .dat, .msg, and .sta files for error messages if the files exist. If there are no error messages and you cannot resolve the problem, please run the command" )
I think abaqus 6.11 can't simulating crock propagation with XFEM method in porous media , is it true?
thank you very much for your attention
- kianoosh's blog
- Log in or register to post comments
- 4425 reads
Comments
error 14x
Hello
errors 14x are not specific to XFEM. It has been discussed in the ABAQUS mailing list
http://groups.yahoo.com/neo/groups/Abaqus/info
The error is quite common when using subroutines and was reported also in one case when using only standard commands.
My advice is to modify the initial, maximum and minimum time increment. Try increasing and decreasing.
Good luck
Frank
------------------------------------------
Ruhr-University
Bochum
Germany
Dear Frank I tried it
Dear Frank
I tried it again with another version of abaqus (6.13) and get error that abaqus cant analysis pore pressure with XFEM .
that error : A xfem analysis with pore pressure degrees of freedom is not supported
thanks :)
Hello,
Hello,
Did you solve the error: "A xfem analysis with pore pressure degrees of freedom is not supported "?
I have exactly the same problem and I have no idea how to solve it.
Thank you in advance.
Juanjo.