Hi everyone,
I am trying to get the history output of
strain and stress tensor components at a node. However after analysis is
finished no such data are saved in the result section. I think Abaqus
only gives the stress and strain for elements and not at nodes. Any help
would be highly appreciated. Please consider that I am a new abaqus
use.
Thank you in advance
Hi everyone,
I am trying to get the history output of strain and stress tensor components at a node. However after analysis is finished no such data are saved in the result section. I think Abaqus only gives the stress and strain for elements and not at nodes. Any help would be highly appreciated. Please consider that I am a new abaqus use.
Thank you in advance
dear all,
i wanted some help regarding the dynamic modelling of IMPACT on plates by BLUNT and HEMISPHERICAL nosed prjectiles with procedures and simulations using ABAQUS.
thanking you all.
-sanjay
Hi everyone,
I am used to use 'dstran, stran, drot...' to develop my user subroutine UMAT and VUMAT codes in Abaqus. But recently I read some publications in which they use dfgrd0, dfgrd1 and dtime to develop their codes. I want to know what are the differences between these two ways?
Thank you very much!
Shunlai
