You are here
Modeling concrete wall covered by FRP under blast load
Mon, 2009-08-17 05:59 - m_meisam
Dear Guys
Is there any one that can help me for below questions?
1- Modeling FRP in abaqus CAE
2- Define interaction between FRP layer and concrete wall
Regards
M.Mojtahedpour
»
- m_meisam's blog
- Log in or register to post comments
- 5137 reads
![Subscribe to Comments for "Modeling concrete wall covered by FRP under blast load"](https://imechanica.org/misc/feed.png)
Comments
re:Modeling concrete wall covered by FRP under blast load
Dear Mojtahedpour ,
1.a thin block with fine mesh would be fine i think, but not sure if you'll get very large deformation.
2.Surface to surface contact should be good, and if you dont need to consider the relative motion between them, a fine mesh on
top of the wall with FRP material properties would be better. BTW.Explicit should be better for shock simulation:D faster~
Hope that will help you a little bit.
Regards,
Chen
Thanks Chen
Dear Chen!
Thanks for help.
Meisam M.