User login

Navigation

You are here

How do I rectify an error regarding memory storage when I generate substructures in ABAQUS?

renganathan sekar's picture

I have been trying to generate a substructure in ABAQUS for a big diameter roller bearing. I have used two reference points, one each for inner and outer raceways to couple the inner and outer raceway surfaces. I have two steps in the analysis. The first step is Frequency followed by Substructure generation step. The analysis runs fine till the end of first step and calculates the eigen frequencies. When the second step starts, following error message appears.

" Element 439473 requires more than 2GB of memory for storage"

Element 439473 is just a point on the outer raceway and it is not used in any of the couplings. I have used continuum distributing couplings for coupling the reference points and the raceway surfaces. Following error also pops up after the element error.

***ERROR: An attempt to access admc buffer has failed. Any help would be truly appreciated.

Thanks in Advance.

Renganathan Sekar


Subscribe to Comments for "How do I rectify an error regarding memory storage when I generate substructures in ABAQUS?"

Recent comments

More comments

Syndicate

Subscribe to Syndicate