Join this webinar and see how Simpleware software adds value to the inspection and non-destructive evaluation of high-value, low-production-volume parts. Register to attend the live webinar or to watch a recording after the broadcast at your convenience.
The use of 3D printed metal structures is taking a very fast ramp-up in industry. General Electric has demonstrated the possibility of printing titanium fuel injectors for their LEAP engine, EADS has printed a nacelle hinge bracket for the Airbus A320, Boeing is printing plastic inlet ducts for high-altitude aircrafts, hip implants and other prosthetics are exploiting the design freedom of additive manufacturing (AM),...
Dear Colleagues,
We would like to invite you to submit an abstract for the ‘ASNT Spring Symposium 2018’ under Track : NDT for Additive Manufacturing. This symposium held at Orlando, FL, USA, March 26–29, 2018.
Normal
0
false
false
false
EN-US
X-NONE
AR-SA
We are looking for a PhD and postdoc researcher in thermographic inspection of composites, in the context of NDT (NonDestructive Testing) and defect detection.
More information can be found on http://www.composites.ugent.be/PhD_job_vacancies_PhD_job_positions_comp….
One PhD (4 years) and two Postdoc (3 years) vacancies are available in the composites research group at Ghent University in Belgium. The different open positions deal with nondestructive testing methods for composites inspection (vibration/thermography) and fatigue of 3D printed metals. More information can be found on http://www.composites.ugent.be/PhD_job_vacancies_PhD_job_positions_comp….
Non-destructive testing (NDT) refers to techniques that are used in the life-cycle of a structural component to investigate their quality, functionality and 'health' without destroying the object, nor affecting its properties. The continuous development of more advanced materials, like fiber reinforced plastics, requires new and more sophisticated NDT techniques. One such an innovative NDT technique is the Ultrasonic Polar Scan (UPS) which has recently been developed, both experimentally and numerically, in our research group.
Stress corrosion cracks can be a serious problem in many engineering industries, and especially so for critical parts. While an ultrasonic transducer can be used for the non-destructive evaluation of cracks with simple shapes, complex branching cracks, such as stress corrosion cracks, require ultrasonic arrays that consist of multiple transducers and are able to inspect at multiple angles.
Novacam 3D Profilometer Software
The Novacam three dimensional software programs are used with all Novacam Profliometers. The program permits the consumer to define how big the region, or line to be measured, along with the lateral resolution from the measurement.
Novacam's high end Data Acquisition Profilometer Software programs are incorporated with all of MicroCam non-contact profilometers.
A RA (MS level) position is available in the Department of Engineering Technology, University of North Texas-Denton in the fields of characterization of piezoelectric crystals, design and modeling of piezoelectric resonators and sensors. The position will start from spring, 2012. Candidates should have a Bachelor/Master's degree in engineering mechanics, mechanical engineering or electrical engineering with good academic standing and should have some experiences in the following:
The National Committee on Applied Mechanics of Engineers Australia is hosting the 6th Australasian Congress on Applied Mechanics (ACAM 6) in Perth, Australia on December 12th-15th 2010.
ACAM 6 (http://www.acam6.org/) aims to provide an international forum for researchers, industry practitioners, engineers and postgraduate scholars to promote, exchange and disseminate knowledge and experiences of the most recent results and advances in a wide range of topics in Applied Mechanics.
