You are here
quasi-static indenation test simulation in ansys Question ?
Sun, 2014-03-09 11:53 - Ahmed wagih
Dear all,
I have aproblem with contact peoblem.
I am working in indentation in composite laminate plate the simulation was done using ANSYS. i define surface to surface contact between the rigid indneter and the laminate plate. then, a small displacemnt is applied to the indenter (.005mm) to check the conatct condition.
THE problem?
when applying this small displacemnt i get very large penetration of indneter in the specimen. and i don't know why?
If any one can help me?
Regards
Ahmed
»
- Ahmed wagih's blog
- Log in or register to post comments
- 1561 reads
Recent comments