Blog posts

for mr vinh phu nguyen

Submitted by maslami on Sun, 07/10/2011 - 13:37

education

hello

dear vinh phu nguyen

Hardness value from Nanoindentation Curve

Submitted by atiwari on Sun, 07/10/2011 - 08:08

research

nanoindentation

Hi,

Is there anyone aware of the reason why there is a surge in hardness value during the initial stages of penetration in nanoindentation curve. In a plot of hardness vs displacement into surface, I record a high value during the initial stages of the run. I am little confused about the reason.

Thanks,

atul

Corner flow

Submitted by Robert G de Boer on Sat, 07/09/2011 - 20:54

education

matlab codes

Submitted by FRANKFURT on Sat, 07/09/2011 - 18:15

hi every ones ,I need for the purpose of my thesis image correlation code sources for strain field generation..thanks

scientific problem in a journal article

Submitted by saeedspace on Sat, 07/09/2011 - 07:44

research

Normal
0

false
false
false

EN-US
X-NONE
AR-SA

How to apply uniformly distributed load to shell element when I do nonlinear analysis of I-BEAM

Submitted by speedeagle on Fri, 07/08/2011 - 21:15

opinion

Hi, everyone:

I am using ABAQUS to do my final dissertation:nonlinear analysis of steel members.

I want to apply UNIFORMLY DISTRIBUTED LOAD to the middle height of the web, I splited the web into top and bottom parts,but nomatter I use 'LINE LOAD' OR 'SHELL edge LOAD' ,it does not work at all.

Thank you so much in advance, any opinion is welcome.

PACAM XII: Minisymposium on “Multiscale modeling and simulation of complex materials and systems”. Call for abstracts

Submitted by Pablo Zavattieri on Fri, 07/08/2011 - 14:52

conference

multiscale modeling

polycrystalline materials

biomimetic materials

hierarchical materials

multifunctional and smart materials

As part of the 12th Pan American Congress of Applied Mechanics (PACAM XII) to be held in Port of Spain, Trinidad, from Jan. 2 to 6, 2012, it is our pleasure to invite you to submit an abstract to the Symposium “Multiscale modeling and simulation of complex materials and systems”.

Abaqus: How to lower the stiffness linear curve of load vs deflection of concrete slab

Submitted by kaizen on Fri, 07/08/2011 - 13:31

software

ABAQUS

Concrete Slab

Dear all,

Iam modelling a simply supported RC slab with Abaqus using Concrete Damaged Plasticity subjected to a concentrated load at the top surface of the slab. I have used element type C3D8R for concrete and truss elements to represent steel bars.

I found the result of FEM showed that the linear part of load versus deflection, i.e. from zero load up to yield load shows a very stiff curve compare to the experimental test results.

Postdoc in Characterisation of Steel

Submitted by info@signatur.dk on Fri, 07/08/2011 - 11:31

job

materials science

mechanical engineering

postdoc

applied mechanics

Technical University of Denmark

The Materials Research Division at Risø DTU, Technical University of Denmark, is seeking candidates for a postdoctoral position in the field of defect characterisation in steel.

Job description

The position is part of a research project funded by the Danish Council for Strategic Research aiming at increasing the fundamental knowledge of steel used in gears and bearings in wind turbines. The position involves the following tasks: