thin films

This is a paper we recently published in JMPS on a study of the mechanical properties on thin films comparing experimental results with discrete dislocation simulations. It provides insight in the strengthening that occurs in thin metal films when surface or interface effects become important.

The abstract is below; the full paper can be downloaded from here

Abstract - Experimental measurements and computational results for the evolution of plastic deformation in freestanding thin films are compared. In the experiments, the stress–strain response of two sets of Cu films is determined in the plane-strain bulge test. One set of samples consists of electroplated Cu films, while the other set is sputter-deposited. Unpassivated films, films passivated on one side and films passivated on both sides are considered. The calculations are carried out within a two-dimensional plane strain framework with the dislocations modeled as line singularities in an isotropic elastic solid. The film is modeled by a unit cell consisting of eight grains, each of which has three slip systems. The film is initially free of dislocations which then nucleate from a specified distribution of Frank–Read sources. The grain boundaries and any film-passivation layer interfaces are taken to be impenetrable to dislocations. Both the experiments and the computations show: (i) a flow strength for the passivated films that is greater than for the unpassivated films and (ii) hysteresis and a Bauschinger effect that increases with increasing pre-strain for passivated films, while for unpassivated films hysteresis and a Bauschinger effect are small or absent. Furthermore, the experimental measurements and computational results for the 0.2% offset yield strength stress, and the evolution of hysteresis and of the Bauschinger effect are in good quantitative agreement.

Selective oxidation induced void growth is observed in thermal barrier coating (TBC) systems used in gas turbines. These voids occur at the interface between the bond coat and the thermally grown oxide layer. In this article we develop the modeling framework to simulate microvoid growth due to coupled diffusion and creeping in binary alloys. We have implemented the modeling framework into an existing finite element program. The developed modeling framework and program is used to simulate microvoid growth driven by selective oxidation in a binary beta-NiAl alloy. Axisymmetric void growth due to the combined action of interdiffusion and creeping is simulated. The sharpness of the void and direction of creeping are considered as parameters in our study. Our simulations show that the voids dilate without any change in shape when creeping is equally likely in all the directions (isotropic). Void growth patterns similar to those observed in experiments are predicted when the creeping is restricted to occur only along the radial and tangential directions. A hemispherical void grows faster compared to a sharp void. The sharpness increases in the case of a sharp void and could lead to interactions with the neighboring voids leading to spallation of the thermally grown oxide layer as observed in experiments.