Hi guys, I'm a Telcommunication Engineer and I'm looking for an open source software to perform thermal simualiotn on a PCB (printed circuit board) with some LDMOS transistor installed to better understand the thermal behaviour.
Can you plese suggest me once?
Thanks
Davide
Hi everyone!
I've been trying ansys for a few weeks but in vain. I'm trying to inject a heat source(laser) on a 2D rect plate. I'm not sure on the corrct way to add the boundary conditions. This is what I do:
1. assuming room temp so i added 298K to the bottom, left and right using define loads >add_temp>lines
2.next i inject a heat source say 1000K using define loads>add_temp_on nodes to a few surface center nodes (meaning the top surface still have undefine boundary conditions)