i am doing the project on laminated composite plate.
i want to know which software is most suitable software used for analysing the laminated composite plate and also its version.
so kindly give the answer for my question.to my email-id vvivek1236 [at] gmail.com
Attached is a computer program, written in Scilab and easily convertible to Matlab, that computes and dsiplays vibrations of prismatic beams forced by a sinusoidal point force. One can impose a variety of boundary conditions, including ones with end masses, springs and dampers. I show several examples. This might be a useful pedagogical item to play around with.
I have similar programs and write-ups for free vibrations of Euler Bernoulli beams and Timshenko beams with variable properties. If any would be interested I would willing to post them too.
Dear All !
Does anyone know how to creat Cohesive Zone in Ansys Multiphysics ? i am studying that but i havent created successfully, pls guide me step by step
I also make one contact in Ansys but, how to make it as Cohesive Zone ? i read in help, it guided me to use command "TB and TBDATA". But the problem is i dont know when and where to use these commads. If you know pls ponit me !
Thank so much !
i am doing final year mechanical engineering. i am doing project in analysis of
delaminated composite material.i dont know how to model a delaminated composite material in ansys.so kindly send the tutorial for that one to my mail-id.(saminathan.mkrishnan [at] gmail.com)
I have formulated a shear-lag model for calculating the variation of stress along carbon nanohorns (CNHs), which are conical shaped wrapped carbon sheets, embedded in an epoxy matrix under axial loading. I found that the stress distribution along the length of CNHs depends on the cone angle of these structures and maximum normal axial stress has a smaller value in CNHs compared to a carbon nanotube (CNT) with same cross-section as of the CNH's tip. Furthermore, I read an article stating that synthesis of CNHs are easier compared to CNTs. However, the only article I could f
Dear Colleague,
We are pleased to send you the updates on the 23rd International Congress of Theoretical and Applied Mechanics (ICTAM2012) of the International Union of Theoretical and Applied Mechanics (IUTAM) that will be held in Beijing, August 19-24, 2012.
I want to model a pressure vessel of metal liner over wraped with a composite jacket which is subjected to internal pressure and temprature using ABAQUS FEA software. I could't get helpful documents yet.Please help me .
my E-mail is gggebreyes [at] yahoo.com
Thanks in advance.
Does anyone have some experience on execution of UMAT subroutine? I have written an UAMT subroutine but I have problem to run it.
I install fortran and in the command line, I write: abaqus job=(input file name) user=(subroutine name).
Please, Provide me some information about this problem.
Does anyone have some experience on execution of UMAT subroutine? I have written a UMAT subroutine but I can not execute.
I install fortran and then
in the command prompt I write : abaqus job=(input file name) user=soil.
