Blog posts
Postdoctoral Position Available at Northwestern University
A postdoctoral associate position is available immediately at the Computational Nanodynamics Group at Northwestern University. This research project focuses broadly on the atomistic and meso-scale modeling of biomolecular materials and their interfaces with engineered polymers. Nanostructural predictions, self-assembly studies, and simulations of mechanofunctional behavior constitute the scope of the project.
Abaqus time submission
Hi all!
I would like to submit a job at a defined time. I know we can do that on the CAE, but I prefere to use command lin, and my current model can't run on CAE. I checked on the help but I don't find how to submit an Abaqus job at a predefined time or to postpone a job of few minutes/hours, from command line.
Can you help me?
Thanks,
Laura
Pull out in fabric
Dear all,
I have been trying to model pull of single yarn in abaqus and model is responding. i got a problem now. I am applying velocity in one of the yarn and I am pulling it out.Boundary conditions are fixed on both the sides. to calculate the force that is being applied on to the fabric, pull out force, I summed up all the reaction quantites RF1,RF2,RF3 and i plotted it against displacement. but the force is touching zero sometimes. i dont know the reason. what could it be?
P.S. : I have attached my pull out graph also.
regards
Compatibility error: Type Volumetric
Hi all
i was performing 2D asymmetric analysis of rim mounting on tire.
i was using hybrid elements and the following error is appearing.
Faculty Positions Computational Mechanics Cardiff University
| 1239BR | |
| Job Title | Lecturer / Senior Lecturer in Computational Mechanics |
| Job Category | Academic - Teaching & Research |
| Career Pathway | Teaching & Research |
low memory o fsi model and good meshing on teeth of gear
Hello everybody,
I am trying to run a cosimulation of fsi model with abaqus 6.12 in heat transfer step. But after running for 0.2 seconds, everything hangs or stops showing your computer is low on memory. Can anybody tell me why this happens? I have to run it for 50 seconds and I am trying it in the workstation computer of 32 GB RAM. Also, can anybody tell me how to make good mesh to teeth of a spur gear?
Thanks
Pratik
I HAVE A REGIONAL UNIVERSITY DREAM --- a speech to the candidates to Rector of Politecnico di BARI
taken from http://rettorevirtuoso.blogspot.com/2013/07/i-have-regional-university-…
Sorry for the spell check --- I did not have time to do it!
I HAVE A REGIONAL UNIVERSITY DREAM
An early history of mechanical testing of/using MEMS
I wrote this report a while back, and a limited printing was circulated by Wright Pattterson Air Force Base. I found a scanned version that I attach for your interest.