software

http://www.youtube.com/watch?v=FpEXD0JW_ys

Dear friends .

                   This is the first time i am using abaqus for analysis. I am doing a moving load analysis of a bridge .I have planned to apply a  distributed load and vary the profile using DLOAD . Do you think its a good idea ?. Can anybody send me an example file of DLOAD.

Thanks and Regards 

Chethan 

Hi everyone!

I've been trying ansys for a few weeks but in vain. I'm trying to inject a heat source(laser) on a 2D rect plate. I'm not sure on the corrct way to add the boundary conditions. This is what I do:

1. assuming room temp so i added 298K to the bottom, left and right using define loads >add_temp>lines

2.next i inject a heat source say 1000K using define loads>add_temp_on nodes to a few surface center nodes (meaning the top surface still have undefine boundary conditions)  

I'm using Ansys 12 for modeling and simulation. can you help me that, how I can enter data loads as boundary conditions for a piezoelectric cantilever beam?

thank you for your assistance. 

hello,

 i am modelling a concrete beam with FRP bonded to beam with the adhesive. i hav tried to simulate adhesive using cohesive element Abaqus(from manual) for the past 2 months, but am getting missing  property definition for those elements.I am not sure the procedure I hav followed is correct, so please send me the procedure for modelling cohesive element and the contact between the adherent faces.

waiting for the  reply

Hello

Can any body tell me hw to solve inverse dynamics problems in adams???