Skip to main content

crack

Shearing effects on the breathing mechanism of a cracked beam section in bi-axial flexure

Submitted by saberelarem on

 The main purpose of this paper is to complete the works presented by
Andrieux and Varé (2002) and El Arem et al. (2003) by taking into
account the effects of shearing in the constitutive equations of a beam
cracked section in bi-axial flexure. The paper describes the derivation
of a lumped cracked beam model from the three-dimensional formulation of
the general problem of elasticity with unilateral contact conditions on
the crack lips. Properties of the potential energy and convex analysis
are used to reduce the three-dimensional computations needed for the
model identification, and to derive the final form of the elastic energy
that determines the nonlinear constitutive equations of the cracked

APS March Meeting Focus session: "Fracture, Friction, and Deformation Across Length Scales"

Submitted by Robin Selinger on

Abstracts due Friday, Nov. 19, 2010 

APS March Meeting Focus session: "Tribophysics: Friction, Fracture and Deformation Across Length Scales"

March 21 - 25, 2011, Dallas, Texas

Details at http://www.aps.org/meetings/march/scientific/focus2.cfm#12.7.3

Invited speakers: Michael Marder (Univ. of Texas); Julia Greer (Caltech)

Organizers: Robin Selinger (Kent State), Jacqueline Krim (NCSU), Noam Bernstein (NRL)

Crack penetration in cohesive zone models

Submitted by phunguyen on

Hi all,

I am conducting some cohesive crack simulations within the framework of XFEM. The cohesive model is an initially rigid traction-separation law for mode I.  In order to deal with negative values of the normal sepration/jump, I use a penalty stiffness K.

help for determination of crack initiation location with analytical methods

Submitted by YangTan on
Free Tags

  There are three elliptical holes in the given plate, but make different angle with the direction of stress applied on the plate. I wonder if I can gain the solution listed below using analytical methods?(1) crack initiation will happen in which ellipse firstly, (2)the exaxt crack initiation location around the ellipse? And how?

 

thanks a lot!

Open PhD position at Mines ParisTech, Centre des Matériaux, Paris, France

Submitted by Nicolas Cordero on
Simulation of crack bifurcation in single crystal nickel base superalloys under mixed mode conditions

PhD position available at the Centre des Matériaux , ParisTech , starting fall 2009.



This 3-year project is fully funded by Mines ParisTech, SNECMA and ONERA.

Stress intensity factors for a slanted crack under compression

Submitted by Julien Jonvaux on

Hello everyone,

Here is the problem I have: I'm modeling the geometry of a simple straight edge crack in a 2D elastic medium using Abaqus. I assume plain stress conditions. The crack makes an angle with the horizontal, is small enough to be considered as embedded in an infinite domain (ratio crack length/size of domain < 1/10) and I apply a vertical compressive load on top of my domain. I fixed one point in displacement at the bottom of it and the whole bottom edge is constrained not to move vertically.