Dear all,
I would like to draw your attention to our recently published research on the simulation of high accuracy fracture growth:
On the use of quarter-point tetrahedral finite elements in linear elastic fracture mechanics, M. Nejati, A. Paluszny, R.W. Zimmerman, Engineering Fracture Mechanics, 2015:http://authors.elsevier.com/a/1RLCT38l3DCPF
Dear all
Please kindly explain how can we introduce wrinkling at abaqus and subsequently
how can we observed wrinkled model at abaqus?
regards
Graduate student applications are invited for PhD positions in the Atomistic and Multiscale Mechanics Group in the Department of Aerospace Engineering at the Iowa State University. Self-motivated students in the area of theoretical, computational and applied mechanics, computational materials science, or condensed matter physics are encouraged to apply. Research topics cover multiscale simulation of dislocation, fracture, phase transformation and heat transfer in materials. Individuals who have research experience in one or more of the following areas are especially desired:
Engineering actuators with capabilities that match and even exceed those found in nature, is a long-standing challenge. While traditional actuators are built with hard materials, it has been recently shown that elastomeric materials enable the design of fluidic actuators that are lightweight, inexpensive, easy to fabricate, and able to undergo large deformation and complex motions. However, these actuators typically rely on large volumes for their actuation.
Super-stretchable, skin-mountable, and ultra-soft strain sensors are presented by using carbon nanotube percolation network–silicone rubber nanocomposite thin films. The applicability of the
strain sensors as epidermal electronic systems, in which mechanical compliance like human skin and high stretchability (e > 100%) are required, has been explored. The sensitivity of the strain
In an article published in the August 20 issue of Nature Communications, we report a mechanochemical phenomenon in graphene oxide membranes, covalent epoxide-to-ether functional group transformations that deviate from epoxide ring-opening reactions, discovered through nanomechanical experiments and density functional-based tight binding calculations.
1. kindly provide me some guidelines for applying material properties in ANSYS workbench to a cylindrical body whose inner portion up to a certain radius is of isotropic and outer portion is of orthotropic..
2. can we provide a texture in a surface of one body which is assembled to other and then perform a analysis in ansys?
thank you.
